GMW IPP 144 - 40 G, User Manual

Page: 38 / 60

5.2. Replacing the paper roll
Proceed as descibed below:
1. For devices with a.c. powersupply be very careul.
2. Push the snap lock to the right hand side and open the
front panel.
3. Tilt the wire frame upwards and remove the old paper
roll.
4. Insert new paper roll and make sure that it rotates
clockwise during printing (see figure 1).
5. Cut a straight edge at the start of the roll using
scissors (figure 2) and fold approx. 2cm of this edge
opposite to the roll direction. Fold this section until it is
about 90 degrees to the rest of the paper (figure 3).
Insert the folded start of the roll into the paper feed slot
as shown in figure 1.
6. Press the „LINE FEED / ENTER“ key until the paper
appears at paper cutting edge.
7. If you have fed too much paper, carefully rewind the roll.
Push the wire frame back over the roll.
8. Close the front panel (snap lock must lock). The Alarm
LED extinguishes and the printer is ready.
Warning: Dangerous voltage
is accessible if replacing the paper roll after
opening of the front panel !
20
37
Version E
SET TIME NO ?
YES ?
SET TIME 15:57:26
_5:57:00
. .
. .
15:4_:00
>>> 15:48:00
TO STORE TIME, PLEASE PRESS „ENTER“
TO SET TIME AGAIN, PRESS „SELECT“
SET CALENDAR
NO ?
YES ?
SET CALENDAR 12.01.2003
_2.01.2003
1_.01.2003
. .
. .
16.02.0_
>>> 16.02.2004
CHANGE TIME W<->S NO ?
YES ?
CHANGE TIME W<->S 14:07:14
W --> S (+1h)
S --> W (-1h)
>>>
15:07:14
PRINT DATE/TIME NO?
YES?
PRINT DATE/TIME CTRL “ ^ “
HEADLINE
>>> HEADLINE
S
ET ACCORDING TO THE BASIC VERSION
SET INTERVAL
SET MODE
SET PRINT STRENGTH
SET BAUDRATE
SET DATA FORMAT
SET PARITY
PRINTER ADDRESS
SET PRINT FORMAT
SET CHARACTER/LINE
SET CHARACTER
SET INTERFACE
*** END ***