Glutz SD-L F 9365 Series, Mounting And Operating Instructions

Page: 23 / 112

SD‑L F (9365x)
0548-988-11---20_2022.01.indd
D F

10 Nm
E
Loctite 243
G

5 Nm
0548-988/12
Page 23 of 87
Mounting and operating instructions
4.4.2 Sliding rods RG pulling function / Lintel mounting
Material:
1 Drive mechanism 0548-042 Covering aluminium
Drive mechanism 0548-043 Covering inox
incl. fixing set 0548-107
1 Mounting plate 0548-358 resp. 0548-360 MOD
1 Sliding rods 0548-164 650 mm incl. sliding bolts 18/46 mm
Procedure:
1. Mark out and drill the fastening holes on the lintel and the door leaf.
Note:
The illustration shows a 46 mm sliding bolt. Depending on the situation, this bolt can
be replaced by the version 18 mm. This will change the respective dimensions by minus
28 mm .
2. Mount the mounting plate.
3. First loosen the screw (G) of the glider (E), then
the bolt (F) of the rotating arm (D).
4. Depending on the situation, select the short
18 mm or long 46 mm bolt (F) and fasten it to the
rotating arm (D) by means of screw locking adhesi -
ve Loctite 243

Tightening moment 10 Nm .
5. Push the glider (E) over the bolt (F) and fasten it by
means of screw (G)

Tightening moment 5 Nm .
Attention:
When tightening the screw (G), the bolt (F) must not come loose!