Glutz SD-L F 9365 Series, Mounting And Operating Instructions

Page: 12 / 112

SD‑L F (9365x)
0548-988-11---20_2022.01.indd
0548-988/12
Page 12 of 87
Mounting and operating instructions
3.3 Inverse application
The swing door drive mechanism SD-L F (9365x) is also appropriate for inversed operation. This
particular function can be separately programmed for each drive mechanism. The inverse applica -
tion is suitable for smoke extraction from buildings (RWA = smoke and heat exhaust vent solution)
as well as for escape and rescue ways. In the event of a power failure or a RWA, this functionality
ensures that the door leaf is reliably opened.
During normal operation, the opening and closing movements of the door leaf are motorized.
The automatically opening is performed via opening elements. The automatically closing starts as
soon as the programmed hold-open time has expired.
Function in the event of a smoke alarm/a mains failure
The door leaf is opened from any position by means of spring power (unless it has not been
locked). The motor attenuation ensures a controlled opening. An emergency power supply system
is therefore not necessary.
Attention:
The inverse function (spring-powered opening) must not be used on hold-open devices or in fire-
protection sections, as this function is contrary to the "self-closing" property (which is required by
the standards)!
3.4 Automatic closing sequence control
For 2 leaves installations, two separate SD-L F (9365x) swing door drive mechanisms with fire pro -
tection rating are used, which are connected via the CAN bus system. In addition, fire protection
installations require the installation of the mechanical closing sequence regulator SD-L F ISR.
Drive mechanism 2
Slave
Drive mechanism 1
Master
Earlier door leaf
the first one to open
the second one to close
Delayed door leaf
the second one to open
the first one to close
3.5 Rating plate
The rating plate (including EC identification) can
be found on the direct current motor (below the
drive mechanism covering).
Rating plate