Glutz SD-L F 9365 Series, Mounting And Operating Instructions

Page: 38 / 112

SD‑L F (9365x)
0548-988-11---20_2022.01.indd
X106

Joystick
Display
1-2-3-
V+SpR-

Joystick
Display
R0-R1-
FP+RP-
0548-988/12
Page 38 of 87
Mounting and operating instructions
Remove the fire protection PCB:
All the PCBs are plugged into the control unit via
a universal connector. A maximum number of
two PCBs can be combined.
Attention:
All the PCBs must only be plugged
into/removed from the control unit
after the dive unit has been discon -
nected from the power supply source!
1. Switch-off the main installation swtich on
the drive mechanism .
2. Remove the fire protection PCB.
3. Attach jumper onto the two pins X106.
4. Switch-on the main installation swtich on
the drive mechanism .
Display E60/30
5. Select menu:
Diagnostics
FPx
6. In the rest position, press in the joystick:
Reset OK?

The fire protection PCB is
deleted from the configuration.
1 Fire alarm central
2 Manual triggering
3 Smoke detector/Thermal switch
- no response
+ Short-circuit
e Wire rupture
--------------------------------------------------------------------------------------------
V Feeding 24 V
+ OK
e Error
--------------------------------------------------------------------------------------------
S DIP-Switch
a active
p passive
--------------------------------------------------------------------------------------------
R Acknowledgement
- not confirmed
+ confirmed
Diagnostics:
The identified fire protection PCB is displayed as
follows in the diagnostic menu:
------------------------------------------------------------------------------------------------------------
R0 Relay PCB with DIP switch on position
Addr0
R1 Relay PCB with DIP switch on position
Addr1
FP Fire protection PCB
RP Radio PCB
------------------------------------------------------------------------------------------------------------
+ identified and ready for operation
- neither identified nor registered
e defective or error
x removed