Chapter 6 — Service and Repair
©2006 Global VR, Inc.
040-0120-01 Rev. B 10/10/2006
Page 33 of 56
c. Disconnect the Color and Sync 4-wire cable that connects from the Chassis Tube
Neck to the Monitor chassis PCB (Item 3 below). Note the color alignment of this
connector for installing the new monitor chassis PCB.
Figure 28.
Monitor PCB Cables
8.
You can now slide the monitor chassis PCB and other PCBs out the side of the monitor chassis
as one unit.
Computer Replacement
The computer is serviced as one unit. YOU WILL VOID YOUR WARRANTY if
you open the computer without direct authorization from the GLOBAL VR
technical support staff.
Shipping the computer without enough padding can VOID THE WARRANTY if
the computer is visibly damaged from shipping.
Disconnect the DVI-to-VGA adapter from the DVI port before shipping the
computer. Leaving the adapter connected can cause damage to the video card.
Perform the following steps to remove the computer from the cabinet:
1.
Disconnect all of the cables and the DVI-to-VGA Adapter from the computer.
2.
Remove the Game Dongle and keep it with your cabinet. Do not ship the game dongle with the
computer.
3.
Note the position of the computer for re-installation. Open the buckle on the strap that secures
the computer in place and carefully remove the computer from the cabinet.
4.
Reverse these steps to replace the computer. Make sure that the computer air vents are not
blocked. There is an air vent under the bottom front panel of the computer that is easily blocked
by padding or debris.
When shipping the computer, always use plenty of padding and protection. GLOBAL VR
recommends shipping the computer in a box with three inches of foam padding on all sides.
Summary of Contents for Aliens Extermination
Page 55: ......
