Chapter 6 — Service and Repair
Aliens Extermination System Manual
Page 32 of 56
040-0120-01 Rev. B 10/10/2006
Figure 26.
Removing the Monitor PCB Mounting Hardware
5.
Disconnect the Chassis Neck PCB from the Chassis Tube Neck of the CRT by pulling back on
the Chassis Neck PCB. You will need to slide the Chassis Neck PCB to the side to clear the
Chassis Tube Neck.
DANGER: The Second Anode Lead (H.V. CRT Feed) can be charged
with a VERY HIGH VOLTAGE even when powered OFF.
6.
Disconnect the second anode lead that connects to the CRT just above the Chassis Tube. Be
very careful as the second anode lead can be charged with a VERY HIGH VOLTAGE even
when powered OFF. Pinch the gray rubber flange and slightly push in to un-hook the metal
prongs that hold the second anode lead to the CRT, shown by the arrows in Figure 27.
Figure 27.
Disconnecting the Chassis Neck PCB and Second Anode Lead
7.
Refer to Figure 28 to disconnect the next three cables:
a. Disconnect the CRT 2-wire ground cable that connects to the Chassis Monitor PCB
(Item 1 in Figure 28).
b. Disconnect the CRT 2-wire ground cable that connects to the Chassis Neck PCB
(Item 2 in Figure 28).
Summary of Contents for Aliens Extermination
Page 55: ......
