GlammFire.
PAG./12
3.1.3 IN-WALL RECESSED INSTALLATION (ONLY ON LUMINOUS 1200)
CAUTION:
Two people may be required for various steps of this procedure.
1.
Prepare a wall with a framed opening of 1181 mm wide x 420 cm high (Figure 11).
NOTE:
The sizing has allowed for 6.4mm around the fireplace insert for ease of installation. This fireplace does not
require any additional venting.
2
.
Choose your method of supplying power to the unit:
- Plug in (you may run the power cord out of the framed wall opening to an existing outlet or install an outlet on a
nearby wall stud within the wall).
- Hard wire the fireplace. (recommended)
AVISO:
Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury to
persons, always use a licensed electrician.
Ensure that the 3-Position Switch is set to the Off position ("O") and that the circuit on which the fireplace is to be
installed has the power cut off at the service panel until installation is complete.
3.
Lift fireplace and insert into opening. (figure 12).
Figure 11. 1181 mm x 420 mm framing.
