6.
Front glass installation:
6.1.
Evenly distribute the supplied wood on the front tray of the fireplace (Figure 4).
6.2.
Carefully mount front glass assembly so that the front glass hooks (4) hang on the front glass mounts on the
fireplace (4) (Figure 5).
6.3.
Use the supplied two (2) Phillips sheet metal screws to fasten the glass assembly tabs to the fireplace (Figure 6).
6.4.
Ensure the fireplace's 3-Position Switch is switched to the Off position ("O").
6.5.
If unit is not hard-wired, Plug fireplace into a 10 Amp, 230-240 Volt outlet.
NOTE 1:
A 13 Amp, 230-240 Volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A
dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when
the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
Figure 4.
Figure 5.
Figure 6.
