GlammFire.
PAG./9
3.1.2 SURFACE INSTALLATION
3.1.2.1(Luminous 1800)
CAUTION:
Two people may be required for various steps of this procedure.
WARNING:
Ensure that the circuit on which the fireplace is to be installed has the power cut off at the service panel
until installation is complete.
1.
Determine the mounting location of the unit so that the wall-mounting bracket can be installed into 3 wall studs.
NOTE:
It is recommended that the mounting bracket be installed 1420 mm off of the ground to maintain an optimized
viewing angle of the flame.
2.
Hold the wall mounting bracket, with the bubble level on the top, on the wall so that the bubble on the level is
centered between the two black lines.
3.
Mark the 4 mounting screw locations, on the wall, ensuring that the wall bracket stays level. (Figure 7)
4.
In locations where the screws are being installed only into drywall, install the supplied wall anchors before installing
the screw (predrill if required).
5.
Secure the wall bracket to the wall using the supplied 38 mm mounting screws and washers into the wall and/or
wall anchors.
6.
Install the bottom support bracket to the wall centered with the wall mounting bracket, using the appropriate
mounting hardware, (350 mm) below the wall mounting bracket. (Figure 7)
7
. Remove the center screw from the bottom of the fireplace. (Figure 8)
Figura 7.
