GlammFire.
PAG./14
4 - CONTROLS
WARNING: This electric firebox must be properly installed before it is used.
The unit can be controlled by either the manual controls which are located on the upper right of the fireplace or the
remote (Figure 7 & 8). The fireplace is supplied with an IR multifunction remote control.
A. Standby -
Turns the unit On and Off
Activated by pressing the Standby button on the remote or the unit.
The unit will turn on with the same functions that it was set to when it was turned Off and the intake
temperature will be indicated on the Floating DisplayTM.
NOTE: When any button is pressed the intake temperature will be displayed on the Floating DisplayTM for
5 seconds.
B. Sleep timer
Press multiple times to change the “SLEEP TIMER” in 0.5hr to 8.0 hr before turning off. The
remaining time on the “SLEEP TIMER” displays. (This icon is green in colour)
C. Flame effect
“FLAME EFFECT” button cycles the unit sequentially through the 4 setting, low flame, High
flame, demo mode and off.
Low Flame
—
This setting will run the flame effect at a low brighness level. (the display will
show F1)
High Flame
—
This setting will run the flame effect at a High brighness level. (The display will
show F2)
Demo mode
—
This setting will slowly pulse the flame effect between low and High brightness.
(The display will show FP)
Off
—
This will turn the flame effect off. If the heater is running, the display will activate and
remain active to read the set temperature and show if the product is on LOW HEAT/ HIGH
HEAT/COOL BLOW.
D. Colour theme -
“Colour Themes” are setting wich change the colour of the fuel bed there are eight
diferente themes.
Theme 1
—
Theme 1 is a “Demo mode” this setting will scroll throught all of the colour
settings you can “Pause” this demo mode by pressing th “Brightness Button” in which
case the display will read I.P to “unpause” press the “Brightness Button” in which case
display will read I.U.
Theme 2-8
—
Themes 2-8 are preset colour that remain static.
E. Brightness -
This button switches themes 2-8 between full brightness and half brightness. This button also
ineracts with the product when set on theme as perviously described above.
F. Heat -
“HEAT” button cycles the unit sequentially through the 4 settings: Low heat, High heat, cool blow and
off. The heat setting will be indicated by na icon in the display. When the flame effect is On the display will
turn off after 5 seconds, however if the heater is being used independantly of the flame effect. The low heat
or High heat icon will appear continuously in the floanting display.
Low heat - This setting will run the heater at low heat this setting wil be indicated by the
“low heat” icon and the letters LO appearin in the display. ( Icon is Orange)
High heat - This icon in the floating display indicates hight heat this setting will be indicated
by the High Heat icon and the letters HI appearing in the display. (Icon is Red)
Cool Blow - This icon in the floating display indicates Cool Blow this setting will be indicated
by the Cool Blow icon and the letters CB appearing in the display. (Icon is Blue)
OFF -
This switches the heater and blowe “OFF”, no icon will be displayed in the floating
display. Note the blower will run for 10-20 seconds after being turned off this is to ensure
the product cools down safely.
