GlammFire.
PAG./7
2
.
Choose your method of supplying power to the unit:
- Plug in (you may run the power cord out of the framed wall opening to an existing outlet or install an outlet on a
nearby wall stud within the wall).
- Hard wire the fireplace.
NOTE: Hard wiring can be done by removing the Plug from the factory fitted cord and completing the wiring according
to National and Local Elecrical Codes.
WARNING: Do not attempt to wire your own new outlets or circuits. To reduce the risk of fire, electric shock or injury
to persons, always use a licensed electrician.
Ensure that the 3-Position Switch is set to the Off position ("O") and that the circuit on which the fireplace is to be
installed has the power cut off at the service panel until installation is complete.
3.
Lift fireplace and insert into opening. The fireplace's mounting trim should be flush against the wall (Figure 3).
4.
Use bubble level (supplied) to level the fireplace within the framing. Adjust as required.
5. (Luminous 1200):
Drive four supplied mounting screws through the four mounting holes located on the inside sur-
face of the fireplace chassis, into wall studs (Figure 3)
(Luminous 1800):
Use the supplied template to mark the 4 screws that secure the installation bar to the wall. Insert
the 4 wall plugs also supplied before insert the 3.8mm screws.
Figure 3.
