GlammFire.
PAG./11
4.
Position the fireplace on a wall at the position where it will be mounted (Figure 10). Use a bubble level (one is sup-
plied) to ensure that fireplace is level on the wall.
5.
Ensuring that at least two key-holes line up with a wall stud (key-holes are spaced at 102 mm centers), mark the
location of four screw locations on the wall (through key-holes).
6.
Remove fireplace from wall and store in a safe place away from traffic
7.
Where marked screw locations do not line up with a wall stud, insert (screw in) one of the two supplied wall
anchors (predrill if required). Repeat if only two screws line up with a wall stud.
8.
Screw all four supplied #8, 38 mm square head mounting screws and washers into the wall and/or wall anchors
leaving 6.5 mm of thread.
9.
Align chosen key-holes with screws and hang fireplace on the wall. Screw heads and washers will fit through keyho-
les and fireplace will slide down into place (screws will slide into narrow part of keyholes).
10.
Tighten all four mounting screws down on fireplace chassis.
11.
Screw the two supplied #8 square head screws through two of the permanent mounting holes which align with a
wall stud.
12.
Carefully replace and install partially reflective glass and glass brackets using screws from step 1.
13.
Refer to Front Glass Installation section for final installation procedures. (page 8)
Figure 10.
