GlammFire.
PAG./15
G. Temp Down
- Press multiple times to lower the heater temperature in 1ºC increments. The lowest
temperature that can be set 5ºC.
Note: Once you stop at your desired temperature this will flash 3 times, then the display will show the room
temperature as detected by the product. If the set temperature is lower than the detected room temperature
the heater will not activate.
H. Temp Up
- Press multiple times to increase the heater temperature in 1ºC increments. The highest
temperature that can be set is 37ºC.
Note: Once you stop at your desired temperature this will flash 3 times, then the display will show the room
temperature as detected by the product. If the set temperature is lower than the detected room temperature
the heater will not activate.
Modos de uso:
Change Celcius (ºC) to Fahrenheit (ºF) - Press the both 3 Dot button and 2 Dot on the unit and hold until beep
is heard and display flashes. (To revert back repeat this action)
Ligar/ Desligar a opção de aquecimento
Resetting the Temperature Cutoff Switch:
Should the heater overheat, na automatic cut out will turn the whole unit
off and it will not come back on without being reset. It can be reset by turning the unit off at the main disconnect
panel and waiting 5 minutes before turning the unit back on.
Remote Control Battery Replacement
—
To replace the battery:
1. Slide battery cover open on the remote control.
2. Correctly install one 3 Volt (CR2032 [longer life] or CR2025) battery in the battery holder.
3. Close the battery cover.
Battery must be recycled or disposed of properly. Check with your Local Authority or Retailer for recycling advi-
ce in your area.
Figure 14. Manual and remote control.
+
+
Floating DisplayTM
- Hold both 1 Dot button and Flame button, on the unit, for 2 seconds,
when the heater has been disabled the display will read “..” and beep.
To enble heat repeat this action.
