Giona Holding Futura 100 TS, Instructions For Installation, Use And Maintenance Manual

Page: 28 / 48

Heat pump water heater
- 28 -
EN
1 GENERAL NOTICES
1.1 Field of use
The heat pump water heater for the production of hot water is only intended to be used for sanitary water heating,
without exceeding the usage restrictions specified herein. To this purpose it must be hydraulically connected to a
sanitary water delivery network. It requires a power supply to operate.
Never use the heat pump for any purposes other than those specified herein. Any other use is to be deemed as
inappropriate and forbidden.
The manufacturer cannot be held responsible for any installation errors and inappropriate equipment use.
1.2 Safety provisions and regulations
The purchaser shall take care of the installation. The Manufacturer shall not be liable for any damages caused by
wrong installation and/or non compliance with the instructions contained in this use and maintenance booklet, and in
particular with those prescribing that:
• the electrical connection must comply with the provisions specified in the relevant paragraph;
• the supplied nylon electrical protectors must be properly installed;
• “the hydraulic safety unit” must be properly installed, intact and in good working order;
• installation and maintenance must be performed by qualified personnel, in compliance with the regulations in
force;
• before starting any maintenance or repair operations on components containing any cooling fluid, a qualified
technician must remove an appropriate amount of the latter, to ensure the risk-free execution of the
operations in question. The coolant must be handled and disposed of in compliance with the relevant
regulations, and must not be dispersed into the environment! (The R134a coolant is CFC-free, not flammable
and not harmful for the ozone layer);
• the maintenance regulations must be observed;
• the equipment must be installed in an appropriate room (to avoid being exposed to frost);
• it must only used for household purposes.
FAILURE TO COMPLY WITH THE ABOVE PROVISIONS WILL RESULT IN THE CANCELLATION OF ANY
WARRANTY RIGHT.
This equipment complies with the provisions contained in the EEC Directives in force.
1.3 Certifications and Markings
The verification has been performed with reference to the following technical standards:

UNI EN 16147;

EN 12102;

EN 60335-1;

EN 60335-2-21;

EN 60335-2-40;

EN 55014-1;

EN 55014-2;

EN 61000-3-2;

EN 61000-3-3;
 EN 50366.