12
INSTRUCTIONS
•
Connect the short silicon tube
3
, with antibacterial filter
1
, to the suction connector
4
. The other tube, with one end connected to the antibacterial
filter with the other end to jar’s lid connector
2
where has been fixed the red float. When the 90% of the volume of the jar is reached there is the
activation of the security float (the float close the aspiration connector on the jar) to the avoid liquid penetration inside the device.
The device must be used on a plan of horizontal operation.
•
Connect the long silicon tube
5
to the other jar's lid connector
6
•
Connect the other end of the long silicon tube
5
to the probe plastic connector
8
then connect the suction probe
9
to it.
•
Connect the power cord to the device then connect the plug to the electrical mains supply.
•
Push switch
7
on position
I
to start suction
•
Unscrew the jar's lid and fill the jar 1/3 full or ordinary water (this for an easy cleaning operations and an rapid reaching of the functionally vacuum)
then rescrew the lid on the jar correctly.
•
Once finished push switch on
0
position and unplug.
•
To extract the accessories and start with cleaning.
WARNING:
Ensure that the IN marker on the filter is on the side facing the collection jar lid and fitted into the “VACUUM”.
A wrong connection causes immediate destruction in case of contact with sucked liquids.
I prepare him it results to have the battery inside discharge, once the equipment to be used, to be able to load it is necessary to connect the cable of the
device to the electric network 230V 50Hz for around 120 ÷ 150 minutes with general interrupter of the out same device.
The autonomy of the battery to full position is of around 45 ÷ 50 minutes with operation in continuous. In the case in which instead the device is furnished
with internal battery discharge, the time of recharge of the internal battery it is of around 8 hours.
Then the cycle of use to 12V has to be 45 minutes ON - 120 minutes in recharge.
The function of the three lights set in side position on the suction top housing is that to furnish the state of position of the battery.
With battery totally position will be turned on the green light, this light it would be had to turn on as soon as we give tension to our equipment, after few
seconds the yellow light mail is turned on in the middle of the three lights (intermediary functioning battery) while the red light is meaning that the battery
is discharged.
The manufacturer cannot be held liable for accidental or indirect damages should the device be modified, repaired without
authorization or should any of its component be damaged due to accident or misuse.
Any minimal modification / repair on the device voids the warranty and does not guarantee the compliance with the technical
requirements provided by the MDD 93/42/EEC Directive and its normatives.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC:
At the end of its working life, the product must not be disposed of as urban waste.
It must be taken a special local authority differeatialed waste collection or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative consequences for the environment and health deriving from inappropriate
disposal and enables the constituent materials to be recovered to obtain significant saving in energy and resourses.
As a reminder of the need to dispose of separately the product is marked with a crossed-out wheeled dustbin.
