GILBARCO VEEDER-ROOT BRCM2.X, Installation And Upgrade Instructions

Page: 1 / 42

MDE-5265E BRCM2.x Installation and Upgrade Instructions · April 2021 Page 1
Introduction
Purpose
This manual provides instructions for installing the FlexPay
™
Connect v2 [which includes a
Back Room Communication Module (BRCM)2.x and a Dispenser Communication Module
(DCM)2.x], or upgrading an existing Distribution Box (D-Box) to a BRCM2.x.
Legacy
®
two-wire data rates are not affected. This solution provides a second data channel for
Applause
™
Media System, EMV
®
, or Insite360
™
over the same physical wiring.
The BRCM2.x communicates with the dispenser DCM2.x to deliver high-speed data. This

high-speed connection can be used for Applause Media System or the future Transmission
Control Protocol/Internet Protocol (TCP/IP)-based EMV payment protocol and other
dispenser applications that require high-speed connectivity.
Intended Users
This manual is intended for Gilbarco
®
-trained and certified Authorized Service Contractors
(ASCs).
Table of Contents
Topic Page
Introduction 1
Important Safety Information 6
Consignes de sécurité importantes 8
Federal Communications Commission (FCC) Warning 10
Supplier’s Declaration of Conformity (PA0422 series) 10
Supplier’s Declaration of Conformity (PA0435 series) 10
Before You Begin 11
Upgrading to BRCM2.x 14
Appendix A: BRCM2.x Communication Diagram 35
Appendix B: Configuring Distribution Boards 40
Appendix C: Troubleshooting 41
MDE-5265E
BRCM2.x Installation and Upgrade Instructions
April 2021