Page 4
MDE-5265E BRCM2.x Installation and Upgrade Instructions · April 2021
Introduction
Figure 3: Generic CRIND with < 9 Dispensers
Third-party
POS
CRIND
Protocol
CRIND
Two-wire
BRCM2.x with
dual D-Box
boards (*)
Ethernet
DCM2.x board,
configured in
generic mode
Pump
Protocol
Pump
Two-wire +
High-speed
Figure 4: Generic CRIND with > 8 Dispensers
Third-party
POS
CRIND
Protocol
CRIND
Two-wire
BRCM2.x with
dual D-Box
boards (*)
Ethernet
DCM2.x board,
configured in
generic mode
Pump
Protocol
Pump
Two-wire +
High-speed
Other D-Box
(*) - The PA0435 model has a single combined D-box and a field wiring board. The CCP
board is also replaced with the HCM board.
on
shows another solution for non-EMV generic CRINDs. In this case,
there is an external current source [such as a Forecourt Communications Interface (FCI) box]
for each pump and CRIND. The pump wiring passes through a BRCM2.x model ending with
02
to add the high-speed signal.
With EMV, the CRIND current loop is no longer used. Therefore for Passport systems
communicating with Gilbarco dispensers, a BRCM2.x ending with
02
is sufficient
(no current loop boards).
Similarly, for generic solutions, the CRIND current loop connection goes idle while the pump
loop remains active and can carry high-speed signal.
Related Documents
Document
Number
Title
GOLD
SM
Library
MDE-3804
Encore
®
and Eclipse Start-up/Service Manual
• Encore and Eclipse
™
• Service Manual
MDE-5018
FlexPay II CRIND Retrofit Kit Installation
Instructions for The Advantage
™
Series
• Encore and Eclipse
• FlexPay EPP and SCR
MDE-5038
FlexPay II CRIND Retrofit Kit Installation
Instructions for Encore 300
• CRIND and TRIND
®
• Encore and Eclipse Installers
• FlexPay EPP and SCR
MDE-5039
FlexPay II CRIND Retrofit Kit Installation
Instructions for Encore 500
• CRIND and TRIND
• Encore and Eclipse Installers
• FlexPay EPP and SCR
MDE-5040
FlexPay II CRIND Retrofit Kit Installation
Instructions for Encore 500 S/E-CIM
™
• CRIND and TRIND
• Encore and Eclipse Installers
• FlexPay EPP and SCR
