GGP ITALY B 28, Operator'S Manual

Page: 28 / 408

• 3 or 4 point blade (Fig. 4)
Wear protective gloves
and fit the blade guard.
– Remove the blade (if fitted) as described in para-
graph 4.
– The guard (1) is fixed to the angle transmission
(2) by four screws (3).
• Cutting line head (Fig. 5)
When using the cutting
line head the additional guard, with line cutting
knife, must always be fitted.
– Remove the blade (if fitted) as described in para-
graph 4.
– The guard (1) is fixed to the angle transmission
(2) by four screws (3).
– Assemble the additional guard (4) fastening it
into place on the guard (1).
4. REMOVING AND REFITTING
THE CUTTING DEVICES
Use only original cutting
devices or ones homologated by the Manu-
facturer.
• 3 or 4 point blade (Fig. 6)
Wear protective gloves
and fit the blade guard.
The fastening nut (5) has a
left-hand thread and so must be unscrewed in a
clockwise direction and screwed up anticlockwise.
– Insert the wrench supplied (2) into the specific
hole in the angle transmission (3) and rotate the
blade (1) by hand until the wrench enters the in-
ner hole, blocking rotation.
– Remove the split pin (4) and unscrew the nut (5)
in a clockwise direction.
– Pull out the washer (6) and the outer ring-nut (7)
and remove the blade (1).
NOTE
The machine is supplied with
some of the components disassembled and the
fuel tank empty.
Always wear strong work
gloves to handle the cutting devices. Mount
the components very carefully so as not to
impair the safety and efficiency of the ma-
chine. If in doubt, contact your dealer.
1. COMPLETING THE MACHINE
1a. “MONO” models (Fig. 1)
– Position the upper part (2) with the front grip's
guard on the drive tube (1).
– Fasten the lower cap (4) inserting the pin (4a) in
one of the three holes on the drive tube.
– Fully tighten the screws (4).
1b. “DUPLEX” models (Fig. 2)
– Loosen the screws (5) and remove the cap (4)
from the support (2).
– Put the handlebar (1) into the seating in the sup-
port (2), located on the drive tube (3), making
sure that the controls are on the right.
– Fit the cap (4), fully tightening the screws (5).
– Fasten the casing (6) of the controls to its cable
fastener (7).
2. MOUNTING THE ROD
(Models with separate rod – Fig. 3)
– Pull out the stop pin (5) and push the lower part
of the rod (4) right down until the stop pin (5) slots
into the hole (6) in the rod. This is easier to do if
you rotate the bottom of the rod (4) slightly in
both directions. The pin (5) is in place when it is
completely lodged in the hole.
– Lastly, tighten the knob (7) securely.
3. FITTING THE GUARDS
Each cutting device is
provided with a specific guard. Never use
guards other than those indicated for each
cutting device.
IMPORTANT
6 MACHINE ASSEMBLY
EN
4. MACHINE ASSEMBLY