JOINON WALLBOX I-CON BASIC recharging unit for electric vehicles
DEVICE INSTALLATION AND CONNECTION
7.
Before proceeding with device installation, remove the packaging, paying particular attention to not damage the
casing.
Make sure there is no condensation inside the packaging. Otherwise, install the device only when it is completely
dry.
All the installation operations must be carried out in compliance with the directive in force.
All operations that involve moving large weights must be done by two people.
Connection must be carried out when the system is de-energised and by qualified personnel.
Scrupulously check that the device is not energised when accessing it inside.
To measure the lack of voltage, use dielectric gloves and safety goggles that are type-approved for electrical
risks.
After completing the installation of the wallbox,
remove the protective film from the front display.
7.1.
GENERAL INSTALLATION REQUIREMENTS
• The device must be installed in a suitable environment that satisfies the information described in chapter
“6.
Preparation for device installation”
. Furthermore, the elements used in the rest of the installation must be com-
patible with the device and compliant with the applicable law.
• The ventilation and work space must be suitable for the maintenance operations according to the directive in
force.
• The external connection devices must be suitable and observe the distance established by the directive in force.
• The section of the connection cables must be suitable for the maximum current intensity.
7.2.
BASIC JOINON WALLBOX I-CON
7.2.1. DEVICE INSTALLATION
1. For device assembly, one of the two following solutions can be selected:
•
Fixing on the wall
2
3
1
