B. Gohl
©
GEOSAT
pro
46
The Glorystar receiver will automatically tune to
Channel 901, RT
News Channel
. A Signal Strength and Signal Quality meter is now
displayed on the connected television screen with a loud beeping
sound emitted from the TV speakers. The beeping pitch will change
when the correct satellite signal is detected. Now it is time to find
the satellite.
This screen shot shows a receiver
that is not properly connected to
the dish. A Signal Level (
S
) of
0-10% indicates that there is not
a good connection between the
receiver and the LNBF. Verify that
a coax cable is directly attached
from the SAT IN port on the rear of
the satellite receiver to the LNBF
on the satellite dish.
A
Signal Level (S)
reading of 50%
or better indicates that the receiver
is connected to a working LNBF.
The low
Signal Quality (Q)
reading at or below 30% indicates
that the dish is not properly aimed
or the LNBF is not properly rotated
to receive the satellite signal.
The Signal Level (S) is important when determining if the
receiver is connected to a working LNBF. A Signal Level
reading of 50% or higher indicates a connection to a working
LNBF, but not indicate finding the correct satellite.
Do not attempt to use pre wire or previously used coax cables
or switches. Do not use splitters for multiple receivers.
Splitters
DO NOT
work!
