www.geosatpro.com
Toll Free 888-483-4673
37
Attach the LNBF Arm to the Elevation Bracket.
Assemble the Elevation Bracket and Post
Clamp. The Post Clamp has two holes
The dish has been correctly assembled
for Measuring the Dish Elevation
Angle using Scale A (10 - 60 degrees)
if a letter B is visible stamped on the
Post Clamp on the left side of the Post
Clamp.
After verifying the Reflector is not warped,
mount the Reflector to the Elevation
Bracket and install the two LNBF Arm
Side Supports. The Side Arm Supports will
perfectly center and support the LNBFs for
optimal reception.
Assemble the Elevation Bracket to the
Post Clamp inserting Structural Bolt A
(part #6) through the hole stamped
A
if
the Dish Elevation Angle is between 10 -
60 degrees. Assemble using hole stamped
B
if the elevation angle is to be between
50 – 90 degrees. Most installations in
the US and Canada will use Elevation
Scale A type assembly. Installations in
Mexico will usually use Elevation Scale
B assembly.
drilled. One hole is stamped with an A and the other with a B.
