www.geosatpro.com
Toll Free 888-483-4673
17
II. Installation
This section will assist in configuring the unit to receive signals from the dish, control
switches and enable a motorized dish. Scan for channels using Blind Scan, or using pre
programmed transponders. Manually add, delete or edit transponders.
II-1.
Channel Search
Press OK. (Default 0000)
Red Button - TP Edit
Blue Button - Signal Beep ON / OFF
II-2.
Motor Set-up
Press OK. (Default 0000)
Red Button - TP Edit
Blue Button - Signal Beep ON / OFF
II-1. Channel Search
1.
Satellite
- Press OK to display list of satellites
- Select the proper satellite. Press OK
2
DiSEqC / DiSEqC 1.1
- Press OK to list switch types
- Select the correct switch port. Press OK
3.
TP Frequency
- Press OK to list programmed transponders
- Select an active transponder. Press OK
4.
LNB
- Press OK list LNB LO type or frequency
- Select LO type or frequency. Press OK
5.
22KHz
(may be controlled with LNB LO setting)
- Press OK to display ON / OFF
- Select the proper switch setting. Press OK
6.
Multi-Dish Switch
- Press OK to display list of switch types
- Select the proper switch. Press OK
7.
Search Options
- Press OK to display list of search types
- Select the desired search type. Press OK
All Channels - Scans satellite preprogrammed
transponders for free & scrambled channels
SAT (FTA) - Scans satellite preprogrammed
transponders for free channels
One TP - Scans selected transponder for free
and scrambled channels
One TP FTA - Scans selected transponder for
free channels
Blind Scan - Searches entire satellite signal
for all available channels
