Georges Renault CVIS II, Operator'S Manual

Page: 23 / 76

6159932410-02
English
23 / 76
PROGRAMMING
The tightening results of the Run Down speed phase are not saved.
3.4 - Final speed phase
Timeout 0 - 99 s. Phase running time.
Stop time 0.01 - 20 s.
The other instructions depend on the tightening strategy (see table below).
Torque 0 to max. value of the spindle.
Angle threshold 0 to max. value of the spindle.
Angle 0 - 9999.5°.
Other press
W
to display the "Motor settings and other parameters" menu.
Optional: current monitoring.
The minimum and maximum electric current values are programmed experimentally: the max. current value must be read during
the test cycle, then the cycle must be run at least 3 times to define the electric current values to be programmed.
3.5 - Action on NOK phase
When a report is rejected (max. torque or angle reached, etc.), it is possible to apply a specific corrective action to the cycle, either
by stopping the cycle or by programming a corrective phase.
Examples: untighten the screw or the 2 screws, restart tightening, etc.
End end of cycle.
Rrv+end run end of cycle.
Jump jump to phase "x".
Rrv+jump Run r jump to phase "x".
Jump OK jump to phase "x", if preceding phase has an accept report
Rrv+jump OK run r jump to phase "x", if preceding phase has an accept report.
Run reverse time 0 - 99 s.
Thread type right/left.
Rotational speed 0 - 100 % (0% to secure the motor in position). Up to 130% in some cases for the run down speed.
3.6 - Run reverse phase
Timeout 0 - 99 s. Phase running time.
Int. time 0.01 - 20 s.
Tightening
strategies
Instructions
Tor
que
Torque
+ angl
e
Angl
e +
to
rqu
e
Min, max torque
Target torque
Safety torque
Angle threshold
Min, max angle
Target angle
Safety angle