Genie Z-34/22IC, Service Manual

Page: 39 / 185

Part No. 128267 Z-34/22 IC 3 - 15
July 2007 Section 3 • Scheduled Maintenance Procedures
REV A CHECKLIST A PROCEDURES
Bleed the fuel system:
Note: Before bleeding the system, fill the fuel tank.
5 Loosen the vent plug/screw located on the filter
head.
6 Operate the hand primer until fuel, free of air,
flows from the vent plug/screw. Tighten the vent
plug/screw on the filter head.
7 Loosen the vent screw, located on top of the
fuel injection pump.
8 Operate the hand primer until fuel, free of air,
flows from the vent plug/screw. Tighten the vent
plug/screw on the injection pump.
9 Clean up any fuel that may have spilled.
10 Attempt to start the engine using the starter
motor for a maximum of 15 seconds, resting the
starter for 30 seconds before trying again.
11 Inspect the fuel filter/water separator for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
Note: Information to perform this procedure is also
available in the
Kubota D905 Operator's Manual,
(Kubota part number 16622-8916-5) OR the
Perkins 403C-11 User's Handbook (Perkins part
number 100816460).
Kubota D905 Operator's Manual
Genie part number
31743
Perkins 403C-11 User's Handbook
Genie part number
97360