Genie Z-34/22IC, Service Manual

Page: 56 / 185

3 - 32 Z-34/22 IC Part No. 128267
July 2007 Section 3 • Scheduled Maintenance Procedures
REV A
a head bolt
b vent plug
c separator head
d filter bowl
e drain plug
2 Place a container under the filter bowl. Loosen
the drain plug located at the bottom of the bowl.
Completely drain the fuel.
3 Loosen the head bolt then rotate the filter bowl
counterclockwise and remove it.
4 Remove the filter element from the bowl.
5 Apply a thin layer of oil to the bowl gasket and
then install the new filter element onto the bowl.
6 Tighten the drain plug and fill the bowl and filter
assembly with clean diesel fuel.
7 Install the filter and bowl assembly onto the filter
head. Torque the head bolt to 65 in lbs / 7 Nm.
8 Tighten the vent plug.
9 Clean up any diesel fuel that may have spilled
during the installation procedure.
CHECKLIST B PROCEDURES
a
c
b
d
e
Bleed the fuel system:
Note: Before bleeding the system, fill the fuel tank.
10 Loosen the vent plug/screw located on the filter
head.
11 Operate the hand primer until fuel, free of air,
flows from the vent plug/screw. Tighten the vent
plug/screw on the filter head.
12 Loosen the vent screw, located on top of the
fuel injection pump.
13 Operate the hand primer until fuel, free of air,
flows from the vent plug/screw. Tighten the vent
plug/screw on the injection pump.
14 Clean up any fuel that may have spilled.
15 Attempt to start the engine using the starter
motor for a maximum of 15 seconds, resting the
starter for 30 seconds before trying again.
16 Inspect the fuel filter/water separator for leaks.
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
Note: Information to perform this procedure is also
available in the
Kubota D905 Operator's Manual
(Kubota part number 16622-8916-5).
Kubota D905 Operator's Manual
Genie part number
31743