Section 4 • Scheduled Maintenance Procedures
Part No. 62401
S-100 & S-105 & S-120 & S-125
4 - 57
January 2010
REV A
CHECKLIST
D
PROCEDURES
a
drive motor
b
brake drain plug
c
drive hub drain plug
d
drive hub
e
pivot bolt
f
mounting bolt
g
adjustment bolt with lock nut
h
drive brake
4 Remove the turntable rotate drive hub mounting
bolts and pivot bolt. Remove the turntable rotate
drive hub with a suitable lifting device of ample
capacity.
Crushing hazard. The turntable
rotate drive hub may become
unbalanced and fall when it is
removed from the machine if it is
not properly supported.
5 Remove the drive brake drain plug from the side
of the drive brake and drain the oil from the
drive brake into a suitable container.
6 Remove the drive hub drain plug from the side of
the drive hub and drain the oil from the drive hub
into a suitable container.
7 Fill the drive hub with oil until the oil is level with
the bottom of the threads. Apply pipe thread
sealant to the plug. Install the plug and tighten.
8 Fill the drive brake with oil until the oil is level
with the bottom of the threads. Apply pipe
thread sealant to the plug. Install the plug and
tighten.
9 Install the drive hub onto the machine. Install
the pivot bolt and the mounting bolts and tighten
the bolts until they are finger tight.
10 Install the turntable rotate drive motor hoses into
the turntable rotate drive motor and install the
turntable rotate drive brake hose into the
turntable rotate drive brake.
Component damage hazard. Hoses
can be damaged if they are kinked
or pinched.
11 Adjust the turntable rotation gear backlash. See
D-5,
Check the Turntable Rotation Gear
Backlash.
12 Install the ground control side fixed turntable
cover onto the machine and tighten the retaining
fasteners.
b
h
a
e
f
g
f
c
d
Summary of Contents for S-100
Page 1: ......