Part No. 62401
Genie S-100 • S-105 • S-120 • S-125
7 - 125
Section 7 • Repair Procedures
First Edition • First Printing
3 Mark the mounting position of the steer sensor
cover on the yoke.
It is very important that the steer
sensor is installed in the exact
position it was in prior to removal.
If the steer sensor is not installed
correctly, the steer function may
operate improperly. If any steer
functions operate improperly after
removing and installing a steer
sensor, see 13-1,
How to Adjust a
Steer Sensor.
4 Remove the steer sensor cover retaining
fasteners. Carefully remove the steer sensor
cover and lay it out of the way.
Component damage hazard. The
steer sensor is a very sensitive
instrument. It can be damaged
internally if it is dropped or
sustains any physical shock, even
if the damage is not visible.
5 Lay the hoses and steer sensor cable out of the
way.
Component damage hazard.
Cables and hoses can be
damaged if they are kinked or
pinched.
6 Mark the mounting position of the steer sensor
activator pin mounted to the top of the yoke
pivot pin.
7 Remove the steer sensor activator pin retaining
fasteners. Remove the steer sensor activator
pin from the machine.
It is very important that the steer
sensor activator pin is installed in
the exact position it was in prior to
removal. If the steer sensor
activator pin is not installed
correctly, the steer function may
operate improperly. If any steer
functions operate improperly after
removing and installing a steer
sensor activator pin, see 13-1,
How to Adjust a Steer Sensor.
8 Loosen the wheel lug nuts. Do not remove
them.
9 Center a lifting jack of ample capacity under the
axle of the yoke and drive hub to be removed.
Do not raise the machine.
10 Block the wheels at the opposite end of the
machine.
11 Raise the machine approximately 6 inches
(15 cm) and place blocks under the chassis for
support.
12 Remove the lug nuts and remove the tire and
wheel assembly.
13 Remove the drive motor mounting fasteners.
14 Slide the drive motor shaft out of the drive hub
and remove the drive motor from the machine.
15 Remove the pin retaining fasteners from the
steering cylinder rod-end pivot pins. Remove
the pins.
AXLE COMPONENTS
Summary of Contents for S-100
Page 1: ......
