Genie GS-2046, Service Manual

Page: 94 / 236

4 - 54 Genie GS-2046 and GS-2646 and GS-3246 Part No. 72972
June 2003 Section 4 • Repair Procedures
REV B
4-6
Tilt Level Sensor
(after serial number 50443)
How to Install and Calibrate the
2° Level Sensor
This procedure is for models equipped with a
2° side / 3° front / 3° rear level sensor.
Tip-over hazard. Failure to install
or calibrate the tilt level sensor as
instructed will compromise
machine stability and cause the
machine to tip over, resulting in
death or serious injury. Do not
install or calibrate the level sensor
other than specified in this
procedure.
Perform this procedure with the
machine on a firm, level surface
that is free of obstructions.
1 Remove the platform controls from the platform.
2 Turn the key switch to platform control and pull
out the red Emergency Stop buttons to the
ON
position at both the ground and platform
controls.
3 Raise the platform 7 to 8 feet / 2.1 to 2.4 m.
4 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
5 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
6 Remove the tilt level sensor box cover retaining
fasteners. Remove the cover.
The tilt level sensor box is located
on top of the chassis at the steer
end of the machine.
If you are not installing a new level sensor,
proceed to step 15.
7 Turn the key switch to the
OFF
position and push
in the red Emergency Stop button to the
OFF
position at the ground controls.
8 Tag and disconnect the wiring harness from the
level sensor, limit switch and alarm.
9 Remove the tilt level sensor box retaining
fasteners. Remove the tilt level sensor box from
the machine.
10 Remove the tilt level sensor retaining fasteners.
Remove the tilt level sensor from the level
sensor box.
GROUND CONTROLS
800-610-4101
ActionRental.com