Genie GS-2046, Service Manual

Page: 91 / 236

Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246 4 - 51
June 2003 Section 4 • Repair Procedures
REV B GROUND CONTROLS
16 Place the new tilt level sensor in the tilt level
sensor box with the "X" on the level sensor
base closest to the long side of the tilt level
sensor box and the "Y" on the level sensor
base closest to the short side of the tilt level
sensor box.
Tip-over hazard. The tilt level
sensor must be installed with the
"X" on the level sensor base
closest to the long side of the tilt
level sensor box and the "Y" on
the level sensor base closest to
the short side of the tilt level
sensor box. Failure to install the tilt
level sensor as instructed could
cause the machine to tip over
resulting in death or serious injury.
17 Install the level sensor box onto the machine.
Install the level sensor box retaining fasteners.
18 Connect the wiring harness to the level sensor,
limit switch and alarm.
19 Turn the key switch to the ground control and
pull out the red Emergency Stop button to the
ON
position at the ground controls.
20 Tighten the level sensor adjusting fasteners
until the bubble in the top of the level sensor is
centered in the circles.
Be sure there are threads showing
through the top of the adjusting
fasteners.
Result: The tilt sensor alarm should not sound.
21 Raise the platform slightly.
22 Return the safety arm to the stowed position.
23 Lower the platform to the stowed position.
Steer end
Non-steer end
a scissor chassis
b tilt level sensor
c level sensor box
d alarm
e box retaining fastener
f level sensor retaining fastener
24 Raise the machine approximately
2 inches / 5 cm.
25 Remove the blocks from under both wheels.
26 Lower the machine and remove the jack.
27 Remove the blocks from the wheels at the
non-steer end of the machine.
28 Block the wheels at the steer end of the
machine.
X
Y
f
e
a
b
d
c
800-610-4101
ActionRental.com