Genie GS-2046, Service Manual, Page: 95 / 236

Part No. 72972 Genie GS-2046 and GS-2646 and GS-3246 4 - 55
June 2003 Section 4 • Repair Procedures
REV B
11 Place the new tilt level sensor in the tilt level
sensor box with the "X" on the level sensor
base closest to the long side of the tilt level
sensor box and the "Y" on the level sensor
base closest to the short side of the tilt level
sensor box. Install the level sensor retaining
fasteners.
Tip-over hazard. The tilt level
sensor must be installed with the
"X" on the level sensor base
closest to the long side of the tilt
level sensor box and the "Y" on
the level sensor base closest to
the short side of the tilt level
sensor box. Failure to install the tilt
level sensor as instructed could
cause the machine to tip over
resulting in death or serious injury.
12 Install the level sensor box onto the machine.
Install the level sensor box retaining fasteners.
13 Connect the wiring harness to the level sensor,
limit switch and alarm.
14 Turn the key switch to the ground control and
pull out the red Emergency Stop button to the
ON
position at the ground controls.
15 Tighten the level sensor adjusting fasteners
until the bubble in the top of the level sensor is
centered in the circles.
Result: The tilt sensor alarm should not sound.
Be sure there are threads showing
through the top of the adjusting
fasteners.
16 Raise the platform slightly.
Steer end
Non-steer end
a scissor chassis
b tilt level sensor
c level sensor box
d alarm
e box retaining fastener
f level sensor retaining fastener
GROUND CONTROLS
X
Y
f
e
a
b
d
c
800-610-4101
ActionRental.com