Interlogix
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
52
EN.100.007-V4.8.C3.(1)
4
Click
Next
until the
Serial Ports
page.
5
Enter the following information:
a
Type a name for the first serial port.
b
From the
Port
drop-down list, select
COM1
.
c
Type
RS485 HALF DUPLEX
.
6
Click
Next > Next > OK
.
7
Click
Apply
in the top-right corner of the
Central Configuration Server
window.
When your changes are applied, a confirmation appears in the window.
8
Click
OK
.
Configure video ports
1
Open the
Central Configuration Server
in Internet Explorer.
2
Click
Equipment
.
3
In the
Equipment
list, select the unit to configure.
4
Click
Video Inputs
.
5
Click the input name you want to use.
6
Under
ENABLE UDP
in the
Network
section, clear the
ALLOW IP FRAGMENTATION
option.
7
Select the
Input format
you want to use, and click
OK
.
8
Click
Apply
in the upper-right corner of the
Central Configuration Server
window.
When your changes are applied, a confirmation appears in the window.
9
Click
OK
.
Enable PTZ
To enable PTZ for VisioWave units, you must create a new PTZ camera for the unit’s serial port
in the Central Configuration Server.
1
Open the
Central Configuration Server
in Internet Explorer.
2
Click
Equipment
.
3
In the
List of Video Equipment
, select the unit to configure.
4
Click
Serial Ports
.
5
Select the serial port you created in
on page 51, and configure it the
same as the serial configuration of the camera.
6
Click
OK
.
7
Click
Apply
in the top-right corner of the
Central Configuration Server
window.
When your changes are applied, a confirmation appears in the window.
8
Click
OK
.
