Bosch
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3
28
EN.100.007-V4.8.C3.(1)
Configuring Bosch H.264 units
This section describes the additional configuration steps required for some Bosch H.264 unit
features to work in Omnicast.
Configure the video resolution
To configure the video resolution for Bosch H.264 units with firmware 4.50 and later, you must
first select a base operation mode.
NOTE
If the unit has two H.264 video streams, the settings for stream2 are limited to the settings
specified for stream1.
1
In the
Physical view
of the Config Tool, select the camera to configure.
2
Click the
Specific settings
tab.
3
From the
Video Mode
drop-down list, select a base operation mode.
Depending on the mode you choose, the available resolutions and video quality settings for
the two H.264 streams change. For example, to enable a video frame rate of 60 frames per
second, select
1:720p 60fps, 2:Copy
.
4
Click
Apply
.
5
Click the
Video Quality
tab.
6
From the
Video data format
drop-down list, select the desired resolution.
7
Click
Apply
.
