To disconnect the probe from the console in the future, turn the collar counterclockwise
and pull the probe straight out and away.
INSERT SD CARD
1. Lift up the bottom of the rubber
cover on the right side of the
console (left figure).
2. Rotate the cover around its pivot
point at the top to expose the SD
card socket and LCD video out jack on the right side.
3. Remove the supplied SD card or another card of up to 32GB capacity from its
packaging. Discard the packaging but save the plastic storage case.
4. Plug the SD card into the socket (right figure above). Be sure the card’s gold
contacts face the rear of the console and enter the socket first. Push in the card
until you feel it spring back and you hear a click.
To remove the card later, push it in gently until you hear a click and the card pops out far
enough for your fingers to grab.
RESET AUTO POWER OFF INTERVAL
By default, the Auto Power Off function of the DCS1700 is disabled. To minimize how
often you must change or recharge the instrument’s batteries, General strongly
recommends that you reset the Auto Power Off interval to 5 or 10 minutes of inactivity at
the front-panel buttons. Having the DCS1700 occasionally power off on its own is only a
minor inconvenience because the unit can be restarted in less than 5 seconds.
To change the Auto Power Off interval:
1. Power on the console by pressing the
button and holding it for at least
3 seconds.
2. Press the
button to open the main menu.
ALBUM
will be highlighted.
3. Press the
once to scroll up to and highlight
SETTINGS
.
4. Press the
button to open the
SETTINGS
submenu.
AUTO POWER OFF
will be
highlighted.
5. Press the
button to open the
AUTO POWER OFF
submenu.
6. Press the
button to scroll down to and highlight the
5
or
10
line.
7. Press the
button to save your selection.
8. Press the
button three times to return to Preview mode.
User Guide
User Guide
User Guide
User Guide
User Guide
User Guide
User Guide
9
