General DataComm SpectraComm SDT, Installation And Operation Manual

Page: 64 / 74

Application Guidelines General Application Information
A-2 SpectraComm SDT 076R174-000
Installation and Operation Manual Issue 4
SC-SDT Configuration Parameters & Defaults
SC-SDT is shipped from the factory with the ordered Default Profile that suits most customer
applications.
Table A-1 lists all configuration parameters, with the Default Configuration Profile #1
settings shown
bold
. Your factory defaults may vary, depending on which profile was ordered
with your unit.
Users can change values from the default setting via Supv or Admin access to the CLI or the web
interface. The Default Profile can be reloaded back into a SC-SDT whenever a “clean baseline” is
desirable prior to downloading a batch file configuration. To accomplish this, type
default all
at the command prompt, or add the
# default all
command uncommented at the start of
your configuration batch file. You may need to reboot the unit.
Table A-1 Configuration Parameters and Defaults
Configurable Option Description Parameters and Defaults
System Prompt Custom prompt A quoted string; 20 chars max
SDT
CLI Inactivity Timer Disconnects CLI session after the
desired interval (in secs) has
elapsed. 0 to 10,000 use 0 to disable
900
HTTP Service HTTP server support for web
management
Enable or
Disable
SNMP Service SNMP server support for SNMP
management
Enable or
Disable
Telnet Service Telnet server support for telnet
management
Enable
or Disable
Mgt interface Set admin state ON (allows xmit &
recv)
Enable or
Disable
Mgt interface IP-address Defines the management IP
address and mask IP address (a.b.c.d)
IP mask (a.b.c.d);
Defines the IP broadcast address
(a.b.c.d) (optional)
255.255.255.255
Mgt route add Defines a static route that adds an
entry to the routing table for a
specific destination IP address or
subnet. Destination IP network address (a.b.c.d)
Destination IP mask (a.b.c.d)
Destination IP gateway (a.b.c.d)
Metric (1-255)
Mgt default route Defines a default route that is the
IP address of the next hop when
no other routes are known. Default router IP address (a.b.c.d)
Mgt route description Describes the management route Quoted string; 72 chars max
Contact sense Configures normal state of contact
Normally open (NO
) or
Normally closed (NC)
Contact sense Configures the device for contact
sensing.
Enable or
Disable
Contact description Describes the purpose of contact (No default)
Port clock invert Sets xmit clock invert phase
Normal or Invert
Port clock speed Sets clock speed and multiplier
Clock speed: 56 or
64
Multiplier: 1 through 32
Port description Describes the use of the port A quoted string; 72 chars max
(no default)