V 10/17
MagicCompact BA04
Troubleshooting
•
37
Troubleshooting
General
ATTENTION:
Faults may be fixed by trained personnel only!
Malfunctions, which arise during operation, are registered together with
emergency stops in a list with date and time indications. An error mes-
sage is displayed on the operating unit of the control unit.
If a fault arises, the plant is not stopped. However, if an emergency stop
arises, the whole plant (or units) is switched off and the emergency stop
mask is displayed on the operating unit.
The alarm horn sounds at the same time with every message (malfunc-
tion or emergency stop).
Problem fixing
Problem/error/malfunction
Procedures/remedy
Alarm has been released:
Message
too little powder
Display flashes in the OptiCenter
Powder shortage in the powder
container
Acknowledge error, fill in fresh
powder
Switch off the alarm, fill in fresh
powder
Alarm has been released:
Message
EMERGENCY STOP
protective switch
Motor malfunction exhaust air fan,
corresponding motor protection
switch has reacted
Let the motor cool down, switch
on the corresponding motor pro-
tection switch again (see wiring
diagram), see also the "Trouble-
shooting" section in the After Fil-
ter operating manual. In the case
of repeated alarm, contact your
Gema service center
