3.
Tighten the nut (2) against the slot (4.1).
Fig.19
®
Done
6.7.2.2 Set the slider
Carry out the following steps:
1.
Screw the adjusting mandrel (6) into the sliding piece (1) until it reaches the
upper edge of the double-disk (7).
Fig.20
2.
Position the sliding piece (1) by releasing the countersunk screw (3) in the slot
(4.1) in the recess in the lantern so that the tip of the adjusting mandrel (6)
lies on the shoulder of the double-disk (7).
3.
Tighten the sliding piece (1) with the countersunk screw (3).
Assembly and installation
Electrical connection with T.VIS control top
430BAL009261EN_2
42
17.04.2023
