Carry out the following steps:
1.
Heat the new valve seat seal in the oven.
–
Temperature: 140 °C (guideline value)
–
Time: 3 - 5 minutes (guideline value)
!
Make sure that the seal can be deformed along the circumference without
much effort. The heating time required depends on the type of oven and can
vary accordingly.
Fig.23:
Oven
2.
Use both thumbs to press the heated valve seat seal into the radial groove at
one point.
!
Valve seat seals made of hard sealing materials must not be greased.
Fig.24:
Place the valve seat seal into the groove
3.
Then use both thumbs/palms to press the valve seat seal in place in the radial
groove.
!
Make sure the valve seat seal "clicks" into the radial groove. The audible
clicking noise indicates that the seal has been fitted correctly.
Maintenance
Removing and Installing the "Shrunk-on” Valve Seat Seal
430BAL013317EN_1
40
11.03.2019
Summary of Contents for Aseptomag AMV
Page 60: ......
