10.8
Removing and Installing the "Shrunk-on” Valve Seat Seal
10.8.1 Removing the Shrunk-on Valve Seat Seal
For information on valve seat seals, see Section 3.4, Page 19
Tools required:
•
O-ring cutter
•
Heat-resistant protective gloves
Caution!
Health hazard due to toxic fumes!
The O-ring cutter cuts the seal with a hot metal tip. At temperatures of more
than 300 °C, toxic fumes can be released.
► Avoid directly inhaling the fumes.
Caution!
Risk of injury due to hot and sharp-edged parts!
The O-ring cutter cuts the seal with a hot metal tip. This process heats up
the seal and possibly also metal parts of the valve.
► When removing the valve seat seal always wear heat-resistant protective
gloves.
Carry out the following steps:
1.
Place the heated metal tip of the O-ring cutter at right angles on the valve
seat seal to be removed.
2.
Cut through the valve seat seal at one point using the O-ring cutter.
!
Pay attention not to damage the edge of the radial groove.
Fig.22:
Cut through valve seat seal
3.
Take out the cut valve seat seal.
®
The valve seat seal has been removed.
10.8.2 Fitting the Shrunk-on Valve Seat Seal
Tools required:
•
Oven (no microwave)
•
Heat-resistant protective gloves
Maintenance
Removing and Installing the "Shrunk-on” Valve Seat Seal
430BAL013317EN_1
11.03.2019
39
Summary of Contents for Aseptomag AMV
Page 60: ......
