GE PanaFlow MV80, User Manual

Page: 69 / 164

PanaFlow™ MV80 & MV82 User’s Manual 57
Chapter 3. Operating Instructions
3.3.4 The Display Menu
Use the Display Menu shown in Figure 56 below to set the cycle time for automatic screen sequencing used in Run
Mode, change the precision of displayed values, smooth the values or enable or disable each item displayed in the Run
Mode screens.
As an example of how to change a Run Mode display item, refer to Figure 56 below. This example shows how to
remove the temperature screen from the Run Mode screens.
Note:
All outputs are disabled while using the Setup Menus.
1. Use the keys to move to the Display Menu.
2. Press the key until Mf Vf Pr Te De T appears.
3. Press
ENTER
to select. Press the key until the cursor is positioned below Te.
4. Press the key until N appears. Press ENTER to select.
5. Press
EXIT
and then
ENTER
to save changes and return to the Run Mode.
Figure 56: The Display Menu
Cycle Time (Sec)
0
Display
Menu
Password
ENTER
ENTER
Use
keys to access menus
Run Mode
Number of Digits
2
Display TC (sec)
1
MF Vf Te Pr De T
Y or N
A1 A2 A3 Fl Dt E
Y or N
If Cycle Time is set to zero, manual advance is required.
Used to set the number of digits displayed after decimal point.
TC = Display Time Constant, used to smooth display.
Mf = Mass Flow
Vf = Volume Flow
Te = Temperature
Pr = Pressure
De = Density
T = Total
A1 = Alarm 1 Status
A2 = Alarm 2 Status
A3 = Alarm 3 Status
Fl = Fluid
Dt = Density
For each parameter:
Select Yes to view parameter in Run Mode.
Select No to hide parameter in Run Mode.
* E = Energy
* Energy EMS Meters Only