GE PanaFlow MV80, User Manual

Page: 65 / 164

PanaFlow™ MV80 & MV82 User’s Manual 53
Chapter 3. Operating Instructions
3.2 Start-Up
To begin flowmeter operation:
1. Verify that the flowmeter is installed and wired as described in Chapter 2 .
2. Apply power to the meter. At start up, the unit runs a series of self-tests that check the RAM, ROM, EPROM
and all flow sensing components. After completing the self-test sequence, the
Run Mode screens appear.
Note:
Starting the flowmeter or pressing
EXIT
will always display the Run Mode screens.
3. Run Mode displays flow information based on system settings. As a result, some of the screens shown in
Figure 53 below may not be displayed. Press the arrow keys to view the Run Mode screens.
4. Press the ENTER key from any Run Mode screen to access the Setup Menus. Use the Setup Menus to configure
the meter's multi-parameter features to fit your application.
Figure 53: Run Mode Screens
Mass Flow
Rate
Volume
Flow Rate
Alarm 1
Status
Alarm 2
Status
Alarm 3
Status
Fluid
Total
Density
Pressure
Setup
Menus
Password
ENTER
ENTER
Press EXIT to
return to
Run Mode
Use
keys to access
each item
Energy
*
Energy EMS
*
Meters Only
Run Mode Screens