GE PACSystems* RX3i, Command Line Interface Manual

Page: 16 / 116

1-10 PACSystems* RX3i PROFINET Controller Command Line Interface Manual
– July 2011
GFK-2572
1
Modify Level Commands
The following commands are additionally available in Modify level.
Command Description
arp [add |clear ]
Non-Global.
clear
clears ARP cache.
add
adds a static entry in ARP table.
blinkId [begin | end]
Non-Global. Begin/End blinking Identification LED pattern.
blinkId
with no
parameters displays whether the pattern is Blinking or Stopped.
clear arp
Non-Global. Clears ARP cache. (Equivalent to
arp clear
.)
clear counters [all |
icmp | igmp | ip |
network |rdnMedia |
tcp | udp]
Non-Global. Clear specified counters or clear all counters.
clear counters
does not clear all counters. Enter
clear counters all
to clear all
counters.
clear log
Non-Global. Clears the local log table and resets the counter of lost log entries.
clear statLED
Non-Global. Reset the STATUS LED (log isn’t cleared). The STATUS LED is
turned on until the next entry is placed into the local log table. This command
does nothing if the module has an invalid MAC Address (STATUS LED Red
and blinking).
default
Non-Global. Returns module to factory default values and logs out of Modify
Access level. Does not affect MAC addresses.
loginCfg [password |
default ]
Non-Global. Change the login password.
loginCfg default
returns login
password to the default. The password setting persists over a power cycle.
logout
Non-Global. Return to Monitor Access Level.
[no] monport
[<monitor> < <ports>]
Non-Global. Display the monitor port and the ports being monitored. Port
monitoring is enabled by specifying the optional
monitor
port and one or more
ports
to be monitored.
no monport
disables port monitoring.
Ping <ip>
Non-Global. Sends ICMP Echo requests.
restart
Non-Global. Restarts the module firmware and logs out of Modify Access level.
sessionTimeout
[<seconds>]
Non-Global. Displays and sets the session inactivity timeout value.
[no] telnetd
Non-Global.
telnetd
enables the telnet server.
no telnetd
command disables
the telnet server. This requires a power cycle to take effect. telnet is disabled
by default. This parameter is preserved over a power cycle.
Time <date> <time>
Non-Global. Changes the internal IO LAN clock.