1-6
PACSystems* RX3i PROFINET Controller Command Line Interface Manual
– July 2011
GFK-2572
1
Command Summary
The tables in this section summarize the PROFINET Controller Command Line Interface commands.
In addition, they indicate the access levels and modes where various commands are valid.
A command that can set a parameter and that has an equivalent
show
command to display the
current value(s) associated with that parameter displays the same information as the
show
command form if the command is entered without any parameters. For example, entering
deviceName
in Configuration mode with no parameters displays the same information as
show
config deviceName.
Commands/parameter names that can be unambiguously interpreted with fewer letters are accepted
as though the full command/parameter were entered. For example, the command
show config ip
displays the same information as
show config i
because there are no other parameters following
show config
that begin with
i
. Likewise, the whole command can be abbreviated
sho co i
.
Commands and parameters (when applicable) are not case-sensitive.
In the tables that follow:
Global
The command is available in all modes and access levels.
Non-Global
The command capability or access to certain parameters change in some modes
or access levels.
[ ]
The parameter is optional. Within the brackets each possible option for that
parameter is listed, with a bar | between parameters.
< >
Parameters that can take on a range of values are shown in angle brackets
Commonly-Performed Tasks
To do this:
Use this command:
Clear the screen
cls
Display configuration of Device Name, IP parameters and
redundant media role
show config or show config all
Display detailed port information.
show port all
Display details on the most recent software exceptions.
show debug exception
Display help for the current access level
help
Display or change shell terminal configuration
shConfig
Display parameters for a command
<command> ?
Display saved fatal error debug data stored non-volatile
memory.
show debug fatalInfo
Display summary of internal and external port information.
show port
Display the local log table
log
End the Command Line Interface Session.
terminate
Go to the Modify access level (Monitor mode)
login
Go to the Monitor access level (Modify mode)
Logout
Restart the module firmware. (Modify mode)
restart
Send ICMP Echo requests.
(Modify mode)
ping
Start the module identification LED blink pattern (Modify mode)
Stop the module identification LED blink pattern (Modify mode)
blinkId begin
blinkId end
