GE MDS RCL220, Manual

Page: 33 / 79

RCL220_manual_v3-draft.doc
05-XXXXA01 Version 3 Draft Page 33 of 79 9/20/2016
DISABLED Com1 data mode disabled
DATA Com1 in Reserved BSP PRAD Data mode
INT_LOOP Com1 in Internal Loopback mode. <Distributor access level>
EXT_LOOP Com1 in External Loopback mode <Distributor access level>
MDM_DEBUG Com1 in MoDeM Debug mode
BAUD=<baud> Read / Write. Set / display baud rate setting.
1200 1200 bps
2400 2400 bps
4800 4800 bps
9600 9600 bps
19200 19200 bps
38400 38400 bps
57600 57600 bps
115200 115200 bps
230400 230400 bps modem debug only
FORMAT=<format> Read / Write. Set / display characters, parity, and stop bits
setting of the COM port. '8N1' format.
7N1 7 char bits, no parity, 1 stop bit
7N2 7 char bits, no parity, 2 stop bits
7O1 7 char bits, odd parity, 1 stop bit
7O2 7 char bits, odd parity, 2 stop bits
7E1 7 char bits, even parity, 1 stop bit
7E2 7 char bits, even parity, 2 stop bits
8N1 8 char bits, no parity, 1 stop bit
8N2 8 char bits, no parity, 2 stop bits
8O1 8 char bits, odd parity, 1 stop bit
8O2 8 char bits, odd parity, 2 stop bits
8E1 8 char bits, even parity, 1 stop bit
8E2 8 char bits, even parity, 2 stop bits
CMD=<cmd> If set to 0, the command executes normally. If <cmd> is set to 1, the
command reports all settings in a format that may be copied into a configuration
script.
3.2.4 COM2
Usage: COM2 {DEFAULT=<default>} {MODE=<mode>} {LEVELS=<levels>}
{BAUD=<baud>} {FORMAT=<format>} {DUPLEX=<duplex>} {CMD=<cmd>}
Description: Set / displays configuration of COM2.
NOTE: CMD=1 short form response command is supported.