GE MDS RCL220, Manual

Page: 32 / 79

RCL220_manual_v3-draft.doc
05-XXXXA01 Version 3 Draft Page 32 of 79 9/20/2016
MOBILITY<mobility> Read Only for all users listed above.
DISABLED Mobility disabled
ENABLED Mobility enabled
FACTDEF=<factdef> Read Only for all users listed above. Enable means change
all configuration settings back to last saved Factory default.
DISABLED Do not reset to factor defaults
ENABLED Reset to factory defaults
FSET<fset > Read Only for all users listed above. Select special company features
set
BASIC Basic generic features set
1 Company features set #1
2 Company features set #2
3 Company features set #3
4 Company features set #4
5 Company features set #5
6 Company features set #6
MAINTBAY<maintbay > Read Only for all users listed above. Maintenance Bay -
serve OTA reprogramming
DISABLED Do not allow Maintenance Bay Mode
ENABLED Allow Maintenance Bay Mode
CMD=<cmd> If set to 0, the command executes normally. If <cmd> is set to 1, the
command reports all settings in a format that may be copied into a configuration
script.
3.2.3 COM1
Usage: COM1 {MODE=<mode>} {BAUD=<baud>} {FORMAT=<format>} {CMD=<cmd>}
Description: Set / displays configuration of COM1.
NOTE: CMD=1 short form response command is supported.
Access Level: Administrator
Optional Arguments:
MODE=<mode> Read/Write for all users, starting at Administrator. This
immediately switches the data port among various interface modes.