GE MDS entraNET Series, Startup Manual

Page: 23 / 32

05-4565A01, Rev. A MDS entraNET Start-Up Guide
19
Table 5 below shows the proper type of Ethernet cable to use with the
radio when connecting to external devices.
LAN/ETH LED does
not turn on. a. Verify that the Ethernet cable is connected at both
ends.
b. Verify that the proper type of Ethernet cable
(straight-through or crossover) is used. See
Table
5
below for the proper cable type.
COM1 or COM2 LED
does not show traffic. Check the configuration of COM port and the remote
serial gateway settings.
Table 5. Proper Ethernet Cable Type
Radio Type Connected Device Cable Type Required
AP Hub or network switch Straight-through
AP PC Crossover
Remote PC Straight-through
Remote Hub or network switch Select for the external
device port
Table 4. Troubleshooting With LEDs
(Continued)
Symptom Possible Cause and Resolution