GE MAC 600 SPY, Service Manual

Page: 71 / 127

Revision G MAC
TM
600 4-21
2047426-002
Maintenance: Preparing System for FRU Replacement
1. Use a disposable wrist strap to avoid static electricity.
2. Open the printer door.
3. Wipe the glazed surface of the thermal print head gently with
wringed swabs dipped in ethyl alcohol.
4. When the surfaces are dry, close the printer door.
NOTE
Do not hit the thermal print head with anything hard.
Do not use sand paper on the thermal print head.
Do not add any unnecessary force on the thermal print head.

Battery maintenance
Refer to the
Battery Maintenance section of the “ MAC 600 operator’s
manual” .

Calibration check
Refer to the
Calibration Check section of the “ MAC 600 operator’s
manual” .
WARNING
PROPER MAINTENANCE REQUIRED — Failure to
implement the recommended maintenance schedule may
cause equipment failure and possible health hazards. All
responsible individuals employing the use of this device
assume the responsibility for performing the
recommended maintenance unless an Equipment
Maintenance Agreement exists.