GE LOGIQ A3, Basic Service Manual

Page: 152 / 252

GE H
EALTHCARE
D
IRECTION
5213326-100, R
EVISION
3 LOGIQ™ A3 S
ERVICE
M
ANUAL
Chapter 8 8-3
8-2-1 LCD ASSEMBLY(FRU P/N # 5271538)
(cont’d)
5.) Unscrew the two screws (A, B) in Figure 8-3 on page 8-3
6.) Lift the LCD Assembly upward to remove it from the system.
NOTE: Please angle the LCD while lifting LCD Assembly upward to remove it from the system. If LCD
Assembly remove with out angling it may damage or break the LCD Cover.
Figure 8-3 Remove LCD Assembly
8-2-1-5 Mounting Procedure
1.) Install new LCD Assembly and fix two screws (A, B). Refer Figure 8-3 on page 8-3
2.) Re connect Power and Signal Cables. Refer Figure 8-2 on page 8-2
3.) Put back LCD arm cover and fix the two screws (5, 6). Refer Figure 8-1 on page 8-2
4.) Replace LCD rear cover by fixing the four screws (1, 2, 3, and 4). Refer Figure 8-1 on page 8-2
8-2-1-6 Functional Checkout Procedure
See Section
Functional and/or
Leakage Current
Test Debrief Script
4-3-1 Power On/Boot Up
Service Manual Direction 5213326-100, Rev 3, Section 8-2-1. Equipment passes all
required tests and is ready for use.
4-4-1 Basic Controls
4-4-2 B- Mode Checks
4-4-3 M-Mode Checks
4-4-4 Measurement Check
Section 7-6 Service Diagnostics
A
B
State: RELEASE - Document is released and under formal Change Control. Changes are subject to the ECR/ECO Process. See the GEHC Myworkshop System to determine the status of this document.
Approved Document - 5213326-100TPH_r3.pdf Page 152 of 252