GE FL000090, Service Manual

Page: 583 / 740

GE H
EALTHCARE
D
IRECTION
FQ091013, R
EVISION
1 V
IVID
I
N AND
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 8 - Replacement Procedures 8-55
8-3-8-5 LCD Display Installation Procedure
NOTE: When performing the following installation procedure steps, it may be helpful to review the appropriate
movie clips previously referenced in the
LCD Display Removal Procedure .
1) Using both hands, carefully lift the replacement LCD Display into position on the Rear Cover &
Latch Assembly (refer to Figure 8-64 ).
Take care not to damage the LEC Flex ribbon cable when performing this step.
2) Use both hands to re-connect the LCD Flex ribbon cable to the BEP - refer to Figure 8-63 on
page 8-53 .
3) Return and fasten the four screws to secure the LCD Display to the Rear Cover & Latch Assembly
(refer to Figure 8-62 on page 8-53 ).
4) Return the LCD Display Frame, as described in the LCD Display Frame Installation Procedure on
page 8 - 28 .
5) Check that the LCD Display can be tilted upwards and downwards , and that it holds its set position.
6) Return the Control Panel and Keyboard as described in the Control Panel and Keyboard Installation
Procedure on page 8 - 11 .
7) Return the bearing handle as described in the Bearing Handle Installation Procedure on page 8 - 4 .
8) Boot-up the system into Maintenance Mode.