GE eBike BASIC, Service Manual

Page: 51 / 234

2018112-069 Rev. F eBike II, eBike II L, eBike II EL - 51 -
nIBp p
araMeter
If the ergometer load is controlled by the internal
programs, this parameter defines the start of the NIBP
module.
Leadtime
Defines the leadtime of the bloodpressure measurement to
the next load step
Setting range: 40 to 90 sec. in 1 sec. steps
Resting NIBP
Defines whether or not a resting bloodpressure
measurement is taken before starting the stress test.
Setting range: OFF - ON
pC-M
ode
PC-Mode „Automatic“
If „YES“ is activated, the ergometer automatically switches
to remote mode (PC mode) as soon as a valid signal is
received from the interface.
s
addle
C
alIBratIon
(eBike II comfort only)
This parameter is used to adjust the electrical saddle
motor. (display scale 1-40)
Select „
TOP Position
“ and confirm with
„ENTER“.
By use of the arrow keys, move the saddle to the desired
top position (standard 36 cm above saddle guidance) and
confirm with „
SET
“.
Select „Bottom
Position
“ and confirm with
„ENTER“.
By use of the arrow keys, move the saddle to the desired
bottom position (standard 7 cm above saddle guidance)
and confirm with „
SET
“.
c
onfiguration of
nibp p
araMeterS
NIBP Parameter
Leadtime
60 sec
Resting NIBP
ON
ENTER
a
utoMatic
M
ode
PC Mode
Automatic
Yes
No
ENTER
c
alibration of electrical Saddle adJuStMent
Saddle Calibration
TOP Position
BOTTOM Position
ENTER
Saddle Calibration
TOP Position
BOTTOM Position
SET