GE eBike BASIC, Service Manual

Page: 128 / 234

- 128 - eBike II, eBike II L, eBike II EL 2018112-069 Rev. F
r
eplaCe saddle Motor
Before you can replace the saddle motor, the
connectionbox and the casing must be removed first.Then
follow these steps to replace the saddle motor:
• Loosen both hexagon socket screws a. of the saddle
guide.
• Remove pin b. with self-locking screw.
• Disconnect plug of cable c. at motor control
(connector 3. in illustration). To do so, first turnjack
plug counterclockwise as far as possible (e.g. using a
suitable fork wrench), then pullout the jack plug.
Open cable tie and pull cable towards the saddlemotor.
Troubleshooting
• Before replacing the saddle motor make sure that
the motor is actually defective.
• For this check, switch the hexagon socket of the
saddlemotor from channel 3 to channel 1 or 2.
• If the motor does not work, it is out of order and
must be replaced.
• If the motor works, the motor control unit or the
hand switch is defective.
Note
• To facilitate pulling in the new saddle motor cable,
attach a draw rope to the cable of the old saddle-
motor
)
• When mounting the new saddle motor, secure the
motor control connection cable with a cable tie d, as
shown in the illustration.